Figure 4-6 Confirmation Message When Disconnecting The Drive In Drive Bay1 - Hitachi HF-W7500 65 Feature Manual

4. CHECKING THE HARDWARE STATUS
7. OFFLINE button
Click this button to disconnect the corresponding drive from the RAID.
This button works only when the drive condition of a drive in the RAID is either
"Normal", "Failure anticipation by SMART", or "Drive usage excess".
In order to disconnect a drive, you must have administrator privileges. Log on to the
computer using an administrator account and click OFFLINE.
If you click OFFLINE, a confirmation message similar to the one shown in Figure 4-
6 will be displayed. To disconnect the drive from the RAID and set the drive to
offline, click Yes. If you click No, the drive will not be disconnected.

Figure 4-6 Confirmation Message when Disconnecting the Drive in Drive Bay1

NOTE
• A disconnected drive cannot be set back to online and used again. When you
disconnect a drive, make sure that the correct drive is selected to be
disconnected.
• You cannot disconnect a drive from a remote session.
4-12