Os Hung-Up Monitoring; Table 2-3 State Of The Equipment In Terms Of Os Hung-Up Monitoring And State Of The Status Lamp; Table 2-4 State Of The Equipment In Terms Of Os Hung-Up Monitoring And State Of The Cpustop Contact - Hitachi HF-W7500 65 Feature Manual

2. ITEMS MONITORED BY THE RAS FEATURE

2.6 OS Hung-up Monitoring

The OS hung-up monitoring function uses a timer implemented on this equipment for
monitoring the operational state of the OS (OS monitoring timer), in order to detect a situation
that a process with the highest priority (real-time priority class) cannot run (hereinafter
referred to as "OS hung-up") due to, for example, runaway kernel or when all CPU load is
used up by a driver. When OS hung-up is detected, this function notifies it using the status
lamp on the front of this equipment.
Table 2-3 State of the Equipment in Terms of OS Hung-up Monitoring and State of the
Status Lamp
During startup of the equipment or when the power
is off
When OS hung-up has not occurred or the system
has recovered from OS hung-up
When OS hung-up has occurred
If you use the CPUSTOP contact of the RAS external contacts interface, an external hardware
connected to the RAS external contacts interface can detect OS hung-up. The following table
shows how the state of the CPUSTOP contact changes.
Table 2-4 State of the Equipment in Terms of OS Hung-up Monitoring and State of the
CPUSTOP Contact
During startup of the equipment or when the power
is off
When OS hung-up has not occurred or the system
has recovered from OS hung-up
When OS hung-up has occurred
When OS hung-up occurs, processes on the OS cannot run as scheduled, and
the facility using this equipment may be affected due to delay in processing. If OS
hung-up occurs, resolve it immediately.
NOTE
• For this function, OS hung-up is defined as a state that a process with the
highest priority (real-time priority class) cannot run.
• When the OS starts, the status lamp is lit green at the timing when this
function starts.
• When the OS shuts down, the status lamp becomes red when this function
stops. It should be noted that when the status lamp turned red, the shutdown
process is not complete. Do not turn off the power at this point.
Status of this equipment
Status of this equipment
NOTICE
2-6
Status lamp
Red
Green
Red
CPUSTOP contact
Closed
Open
Closed