Figure 8-3 Description Of Each Part In The Simulation Tool Window - Hitachi HF-W7500 65 Feature Manual

(3) Using the Simulation Tool window
When the RAS software transitions to the simulation mode, the Simulation Tool
window appears as shown in the following figure.
You can use the Simulation Tool window to change the condition of hardware
devices.
When the Simulation Tool window starts, all hardware devices are set to the normal
status.
Shows the name of
a simulated device.
Click Apply to apply
the "Setting".

Figure 8-3 Description of Each Part in the Simulation Tool Window

8. SIMULATING THE HARDWARE STATUS
Shows the currently set
status of the target device.
8-7
Shows a new status
to be simulated.
Click End to exit
the simulation mode.