Table of Contents
Advertisement
Battery
Detaching battery：
Press and hold the battery remove
button, then push the battery out
of the battery compartment.
Battery Level Indication
Make sure the battery pack is securely loaded in the flash. Check the battery
level indication on the LCD panel to see the remaining battery level.
Battery Level Indication
Meaning
3 grids
Full
2 grids
Middle
1 grid
Low
Blank grid
Lower battery, please recharge it.
Blinking
The battery level is going to be used out, and
the flash is not functional in this status.
Note: Please recharge the battery as soon as possible
(within 10 days). Then, the battery can be used or be
placed for long period.
Power Management
Use ON/OFF power switch to power the flash unit on or off. Turn off if it will
not be used for an extended period of time.
Setting as a transmitter unit, the flash will turn the power off automatically
after a certain period (approx. 90 seconds) of idle use. Press the camera
shutter halfway or press any flash button will wake up the flash unit. Setting
as a receiver flash, it will enter sleep mode after 60 minutes (or 30 minutes)
of idle use. Pressing any flash button will wake it up.
Note:
1. Setting the C.Fn-STBY function to OFF is recommended when the flash is used
off camera.
2. Auto power off timer function of a receiver unit is set to 60 minutes by default.
Another option "30 minutes" is available in C.Fn-RX.
3. The LCD panel will lighten on when operating the buttons or select dial.
Modeling Lamp
Press the modeling lamp button to set
the modeling lamp, press the set button
to turn on or off the modeling lamp.
When turning the modeling lamp on, turn
the select dial to adjust its brightness in
10 levels (01~10).
Mounting/Detaching the Camera Flash
Mounting the camera flash:
Press the hot shoe fixing buckle and
rotate it to the left, insert the camera
flash into the camera's hot shoe.
Installing battery:
Insert the battery into the battery
compartment in the direction
as referred below until it's firmly
locked.
30
Then rotate it to the right until it locks
up.
Detaching the camera flash：
Press and rotate the hot shoe fixing
buckle to the left until it is loosened,
then take off the camera flash.
Installing/Detaching SU-1
Installing:
Align the detachable sub flash
SU-1 with the external flash
interface of V1Pro N and insert
it parallelly, then press it down, a
"click" sound means it's properly
installed.
Using SU-1
With detachable sub flash SU-1 attached
to the external flash interface of V1Pro N,
better filling light effects can be achieved
in M (manual) flash/TTL auto flash mode,
this is helpful for portrait shooting.
Instructions for Using
Mount SU-1 directly to the external flash
interface of V1Pro N, press the MODEL
button to set the flash to M (manual)
flash/TTL auto flash mode, then press
function button 4 <SUB> to enter sub
flash settings interface, and press
function button 3 <ON/OFF> to turn on/
off.
When the sub flash is turned on, turn the
select dial can adjust flash output of the
sub flash from 1/128 to 1/1 in 22 flash
steps, with +1/3 increment each step.
Note ：
1. SU-1 is not useable in wireless transmission shooting.
2. SU-1 is not useable in high-speed sync.
3. The flash head need to be uplifted in order to use SU-1 properly.
Detaching:
Push the detaching pusher on
SU-1 and pull it up at the same
time to detach it.
31
Advertisement
Table of Contents
