Lenovo ThinkSystem SR250 V3 Reference page 15

Hide thumbs Also See for ThinkSystem SR250 V3:
Table of Contents

Advertisement

Table 2. Events organized by severity (continued)
Message String
Event ID
FQXSPEM4027I
Drive error was detected by RAID controller. Please check the event
logs and if events are targeted to the same disk then replace the drive.
If necessary, contact technical support for additional assistance.
([arg1],[arg2],[arg3],[arg4],[arg5])
FQXSPEM4028I
The port [arg1] of PCIe device [arg2] at [arg3] has link [arg4].
FQXSPEM4029I
All PCIe slots on [arg1] may not be functional based upon your current
CPU population.
FQXSPEM4030I
A scheduled operation on the RAID controller has encountered an
issue. Refer to RAID Logs under Server Management, Local Storage,
for details.([arg1],[arg2],[arg3],[arg4],[arg5])
FQXSPEM4031I
SSD wear threshold setting is changed from [arg1] to [arg2] by user
[arg3] from [arg4] at IP address [arg5].
FQXSPEM4032I
Acoustic Mode [arg1] has been engaged. Fan speed limits are in
place.
FQXSPEM4033I
Acoustic Mode [arg1] has been disengaged to allow adequate
cooling.
FQXSPFC4000I
The bare metal connection process has been started.
FQXSPFC4001I
The bare metal update application reports a status of [arg1].
FQXSPFC4002I
System running in setup.
FQXSPFC4003I
UEFI deployment boot mode is enabled for NextBoot.
FQXSPFC4004I
UEFI deployment boot mode is enabled for NextAc.
FQXSPFC4005I
UEFI deployment boot mode has been disabled.
FQXSPFW0003I
The System [ComputerSystemElementName] encountered firmware
progress.
FQXSPIO0000I
The connector [PhysicalConnectorElementName] has been
connected.
FQXSPIO0010I
A Correctable Bus Error has occurred on bus [SensorElementName].
FQXSPIO2001I
The connector [PhysicalConnectorElementName] configuration error
has been repaired.
FQXSPIO2003I
System [ComputerSystemElementName] has recovered from a
diagnostic interrupt.
FQXSPIO2004I
Bus [SensorElementName] has recovered from a bus timeout.
FQXSPIO2006I
System [ComputerSystemElementName] has recovered from an NMI.
FQXSPIO2007I
A PCI PERR recovery has occurred on system
[ComputerSystemElementName].
FQXSPIO2008I
A PCI SERR on system [ComputerSystemElementName] has
deasserted.
FQXSPIO2010I
Bus [SensorElementName] has recovered from a Correctable Bus
Error.
FQXSPIO4002I
GPU Board Status was recovered by [arg1] of [arg1].
Severity
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
.
Chapter 2
XClarity Controller events
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

7dcl7dcm

Table of Contents