Installing The Dec Motor - Vixen Starbook-S User Manual

Installing the DEC Motor

(1) Attach the spur gear to the DEC shaft facing the flat side of the spur gear outward. Orient
the spur gear so that the setscrew is over the flat portion of the DEC shaft as shown in the figure.
Put the spur gear into the dead end of the shaft and tighten the setscrew by using the supplied
1.5mm Allen wrench.
(2) Attach the DEC motor so that its dovetail attachment base fits the counterpart bracket on the
DEC body as shown in the figure. Engage the gears so that the two are flush. At the same time,
connect the DEC motor with the supplied bolt (short) through the hole of the bracket by using the
supplied 5mm Allen wrench.
* Make sure that the gears are engaged properly after you install the DEC motor.
(3) Push and fit the DEC motor gear cover over the DEC motor as shown in the figure.
*Take care not to break the claws on the cover.
(4) Attach the vanity cap to cover the DEC shaft on the opposite side.
12