Vixen Starbook-S User Manual page 11

motor with the supplied bolt (long) through the hole just above the altitude adjustment screw by
using the supplied 5mm Allen wrench.
* Make sure that the gears are engaged properly after you install the RA motor.
(7) Turn the altitude adjustment screw until the altitude of the mount goes up to the latitude of
your observation site.
(8) Connect the motor control board (combined with motor cover) and the RA motor with the
electric wires. Hold the connector of the electric wires with your fingers so that the blue electric
wire is on the left side as shown in the figure. Plug the connector into the socket on the RA motor
securely.
*Take care not to tear apart the electric wires.
(9) Attach the motor control board (combined with motor cover) on the RA body by sliding it onto
the guide rail as shown in the figure. Put the space filler onto it at the point where the motor
gears are hidden behind the motor cover, then slide up the motor cover to the end and securely fix
the motor cover in place with the screw.
11