Elektra Beckum TopLine TKHS 315 E Operating Instruction page 28

Swivel arm plate installation
Qty. Description
1 Swivel arm plate
2 Hexagon head screw M8 x 20
2 Hexagon nut M8
2 Washer A8.4 x 17
1 Cup square neck screw M8 x 20
1 Turn handle, red, M8
1 Washer A8.4 x 17
1. Attach the swivel arm plate to the fastening
bracket with two each hexagon head screws,
washers and hexagon nuts as illustrated.
2. Fit the cup square neck screw through the blade
tilt lever and the oblong hole of the swivel arm
plate. Put the washer on the screw and screw on
the turn handle.
- If necessary adjust the blade tilt lever so that
the cup square neck screw can freely move in
the oblong hole.
3. Screw down the blade tilt lever to the motor car-
rier unit.
Motor and cover plate installation
3
Motor 1.7 WNB:
Install motor first, then the cover plate!
Motor 2.2 WNB and 2.8 DNB:
Install cover plate first, then the motor!
Motor installation
Qty. Qty.
(1.7 WNB) (2.2 WNB
and
2.8 DNB)
1 1 Motor
3 4 Hexagon head screw,
prevailing torque type
M6 x 16
3 – Pan-head tapping screw
3 4 Washer A6.4
1. Fasten motor with hexagon head screws and
washers to the motor carrier unit.
2.7
Item
11
2
4
6
17
12
49
Description Item
112
(motor 1.7 WNB shown in the illustration)
2. Fasten motor enclosure with three pan-head
tapping screws to the motor carrier unit (motor
1.7 WNB only).
Cover plate installation
Qty. Description
1 Guard plate
Cross recessed raised cheese
2
head screw M4 x 12
2 Washer A4.3 x 9
Hexagon nut M4
2
1. Raise the motor with the handwheel upwards as
far as possible.
2. Fasten the cover with cheese head screws,
washers and hexagon nuts to the motor carrier
unit.
Item
45
48
46
47
TKHS 315 E