Cleaning; Troubleshooting; Accessories; Repairs - Metabo WBA 11-125 Quick Original Instructions Manual

ENGLISH
ENG
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine with
both hands using the handles provided, stand in
a safe position and concentrate.
Slide switch:
To switch on: Push the slide switch (5) forward.
For continuous activation, now tilt down-
wards until it engages.
To switch off: Press the rear end of the slide
switch (5) and release it.
9.2 Working instructions
Grinding:
Press down the machine evenly on the surface and
move back and forth so that the surface of the
workpiece does not become too hot.
Roughing: position the machine at an angle of 30°
- 40° for the best working results.
Separating:
Always work against the run of the
disc (see illustration). Otherwise
there is the danger of the machine
kicking back from the cut out of
control. Guide the machine evenly at
a speed suitable for the material being processed.
Do not tilt, apply excessive force or sway from side
to side.

10 Cleaning

Motor cleaning: blow compressed air through the
rear ventilation slots of the machine regularly,
frequently and thoroughly. Here, the machine must
be held firmly.

11 Troubleshooting

Machines with VTC and TC electronics:
The electronic signal display (6) lights up
and the load speed decreases. The coil
temperature is too high! Run the machine in
idling until the electronics signal indicator switches
off.
Machines with VTC, TC, VC and C electronics:
The electronic signal display (6) flashes
and the machine does not start. The
restart protection is active. If the mains plug
is inserted with the machine switched on, or if the
current supply is restored following an interruption,
18
0
I I
the machine does not start up. Switch the machine
off and on again.

12 Accessories

Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Roughing disc (always use with safety guard
attached)
B Parting safety guard.
C Parting disc (always use with parting safety
guard attached)
D Diamond discs (always use with parting safety
guard attached)
E Cup wheel guard (place on machine and
secure with screws (f)). Secure cup wheel as
described in chapter 8. Use the wing screws
to adjust the safety guard until the cup wheel
protrudes between 0.5 cm - 1 cm.
F Cup wheels (always use with cup wheel safety
guard attached)
G Parting safety guard with guide slot (place on
machine and secure with screws.) (with
adapter for connection to a suitable dust
extractor for extraction of stone dust gener-
ated when cutting stone slabs.)
H "Quick-Stop" clamping nut
For a complete range of accessories, see
www.metabo.com or the main catalogue.

13 Repairs

Repairs to electrical tools must be carried out
by qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
power tool.

14 Environmental Protection

The sanding dust generated may contain
hazardous materials: do not dispose of with the
household waste, but at a special collection point
for hazardous waste.
Metabo's packaging can be 100% recycled. Scrap
power tools and accessories contain large