Table of Contents
Advertisement
3.
Hold down (E) for at least two seconds.
Release the button when the hour setting
starts to flash.
The
(alarm) indicator is displayed
●
when any alarm is turned on.
Alarm hour
4.
Use (A) and (C) to change the hour setting.
Holding down (A) or (C) scrolls through
●
settings at high speed.
If you are using 12-hour timekeeping,
●
[P] indicates p.m.
5.
Press (D).
This causes the minutes digits to flash.
Alarm minute
6.
Use (A) and (C) to set the minute setting.
7.
Press (E) to complete the setting
operation.
Note
If you do not perform any operation for
●
about three minutes while in the Alarm
mode, the watch automatically returns
to the Timekeeping Mode.
Watch Operation Guide 3553
To stop the alarm
●
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
Snooze causes the alarm to sound up to seven
times, at five-minute intervals. To cancel a
snooze alarm, turn [SNZ] off.
Turning Off an Alarm or the Hourly Time
l
Signal
Note
A beeper sounds for 10 seconds when
●
an alarm time is reached.
Configuring the Hourly Time
Signal Setting
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (A) or (C) to display the hourly time
signal screen ([SIG]).
3.
Press (B) to toggle the hourly time signal
between enabled and disabled.
●
display while the hourly time signal is
turned on.
(hourly time signal) is shown on the
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
To have an alarm or hourly time signal
●
sound again, turn it back on.
Note
Indicators are displayed while any of
●
the alarms or the hourly time signal is
turned on.
The applicable indicators are not
●
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
Hourly time signal
Alarm
Snooze
16
Advertisement
Table of Contents
