Configuring The Hourly Time Signal Setting; Turning Off An Alarm Or The Hourly Time Signal; Stopwatch; Measuring Elapsed Time - Casio G-SHOCK G-5600UE-1 Manual

Configuring the Hourly Time
Signal Setting
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (D) to display the hourly time signal
screen ([SIG]).
3.
Press (A) to toggle the hourly time signal
between enabled (on) and disabled (off).
[SIG] (hourly time signal) is shown on
●
the display while the hourly time signal
is enabled.
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
To have an alarm or hourly time signal
●
sound again, turn it back on.
Note
Indicators are displayed while any of
●
the alarms or the hourly time signal is
turned on.
The applicable indicators are not
●
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
Alarm
Snooze Hourly time signal
Watch Operation Guide 3496
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Use (D) to display the item whose on/off
setting you want to change: alarm number
[1] to [4] or [SNZ], or the hourly time signal
([SIG]) screen.
3.
Press (A) to turn off the displayed alarm or
the hourly time signal.
Each press of (A) toggles between ON
●
and OFF.
Turning off all alarms will cause [ALM]
●
(alarm) to disappear from the display,
while disabling the hourly time signal
causes [SIG] (hourly time signal) to
disappear from the display.
Note
If [ALM] (alarm) is still displayed, it
●
means that another alarm is still turned
on. To turn off all of the alarms, repeat
steps 2 and 3 until the [ALM] (alarm)
indicator is no longer displayed.
Alarm or hourly time signal

Stopwatch

The stopwatch can measure elapsed time up
to 23 hours, 59 minutes, 59 seconds (24
hours).

Measuring Elapsed Time

1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
2.
Use the operations below to measure
elapsed time.
D
Start
D
Stop
D
Resume
D
Stop
Elapsed time is shown in 1/100-second
●
units for the first hour of the
measurement. After the first hour,
elapsed time is shown in one-second
units.
First hour After first hour
Minutes, seconds, Hour, minute, second
1/100 seconds
3.
Press (A) to reset the stopwatch to all
zeros.
12