Table of Contents
Advertisement
To start measurement
●
1.
Enter the Altimeter Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least five seconds.
Release the button when [Trek] and
mountain climbing graphic segments
appear on the display.
This starts recording of altitude data (high/
low altitude, cumulative ascent/descent).
Mountain climbing
graphic segments
Mountain climbing graphic segments
●
flash or are displayed around the
periphery of the display while recording
is in progress. Each segment
represents 12 minutes, and one lap
around the periphery represents 12
hours.
To stop measurement
●
1.
Enter the Altimeter Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least five seconds.
Release the button when [Trek] [END]
appears on the display.
This stops altitude data (high/low altitude,
cumulative ascent/descent) recording.
Note
If you want to record more than 15 data
●
records, delete old records to make
room for the new data.
Deleting a Particular Record
l
Watch Operation Guide 3553
Auto Record and Climb Record Data
●
Contents
The altitude data below is recorded by auto
record and climb record operations.
Start point
A
High Altitude (MAX):
Low Altitude (MIN):
Cumulative Ascent (ASC):
Cumulative Descent (DSC):
* Cumulative ascent and cumulative descent
values are updated whenever there is a
difference of at least ±15 m (±49 feet) from
one reading to the next.
Note
In the case of auto record data, the
●
auto record operation ends if you exit
the Altimeter Mode. Re-entering the
Altimeter Mode restarts recording of
cumulative values from where it was
stopped when you last exited the
Altimeter Mode.
For climb record data, auto
●
measurement continues even if you
exit the Altimeter Mode.
E
C
D
B
F
End point
E
F
+
*
A
C
+
*
B
D
Specifying the Altitude
Measurement Unit
You can select either meters (m) or feet (ft) as
the Altimeter Mode display unit.
Important!
When Tokyo (TYO) is set as the Home
●
City, the altitude unit is fixed as meters
(m) and cannot be changed.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (E) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
Example: When your Home City is
London
3.
Press (D) 12 times.
This displays [UNIT].
4.
Use (A) to select an altitude unit.
[m]: Meters
[ft]: Feet
Meters
5.
Press (E) twice to complete the setting
operation.
Home City
Feet
24
Advertisement
Table of Contents
