Configuring The Hourly Time Signal Setting; Turning Off An Alarm Or The Hourly Time Signal; Using The Dive Function - Casio G-Shock Frogman GW-8230B-9AER Operation Manual

Configuring the Hourly Time
Signal Setting
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Use (D) to display the hourly time signal
screen ([SIG]).
3.
Press (A) to toggle the hourly time signal
between enabled and disabled.
[SIG] (hourly time signal) is shown on
●
the display while the hourly time signal
is enabled.
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
To have an alarm or hourly time signal
●
sound again, turn it back on.
Note
Indicators are displayed while any of
●
the alarms or the hourly time signal is
turned on.
The applicable indicators are not
●
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
Alarm
Snooze Hourly time signal
Watch Operation Guide 3521
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (D) to scroll through alarms ([1] to
[4], [SNZ]) until the one you want to
configure is displayed.
Alarm number or hourly time signal
3.
Press (A) to turn off the displayed alarm or
the hourly time signal.
Each press of (A) toggles between on
●
and off.
Turning off all alarms will cause [ALM]
●
(alarm) to disappear from the display,
while disabling the hourly time signal
causes [SIG] (hourly time signal) to
disappear from the display.
Note
If [ALM] (alarm) is still displayed, it
●
means that another alarm is still turned
on. To turn off all of the alarms, repeat
steps 2 and 3 until the [ALM] (alarm)
indicator is no longer displayed.
Using the Dive
Function
You can use the procedures in this section to
measure dive times and surface intervals. The
watch also records dive log data
automatically. There is memory for up to 10
dive log data records. Recording dive log data
when there are already 10 log data records in
memory causes the oldest log record to be
deleted automatically to make room for the
new one.
You can use diving log data to view the
●
items below.
Dive start date and time
ー
Dive time
ー
Surface interval
ー
You can use the Log Data Recall Mode to view
recorded dive log data.
Viewing Dive Log Data
l
Important!
If the battery is low or dead, charge it
●
before using the watch for diving.
Before starting a dive (while still on a
●
boat or the water's surface), enter the
Dive Mode.
12