Casio G-Shock GW-9500-1A4 Installation Instruction page 37

Digital Compass
Q1
The entire display is flashing.
Abnormal magnetism has been detected.
Move away from any potential source of
strong magnetism and try taking a reading
again.
Digital Compass Reading Precautions
l
If the display flashes again, it could mean
●
that the watch itself has become
magnetized. Move away from any potential
source of strong magnetism, perform 2-
point calibration, and then try taking a
reading again.
Calibrating Compass Readings
l
Q2
[ERR] appears during measurement.
There is a problem with the sensor or there
may be a source strong magnetic force
nearby. Move away from any potential source
of strong magnetism and try taking a reading
again. If [ERR] keeps appearing after multiple
measurement attempts, contact a CASIO
service center or your original retailer.
Digital Compass Reading Precautions
l
Q3
[ERR] appears following 2-point
calibration.
[ERR] on the display could indicate a sensor
problem.
If [ERR] disappears after about one second,
●
try performing 2-point calibration again.
If [ERR] keeps appearing after multiple
●
attempts, contact a CASIO service center or
your original retailer.
Q4
Direction information indicated by the
watch is different from that indicated
by a backup compass.
Move away from any potential source of
strong magnetism, perform 2-point
calibration, and then try taking a reading
again.
Calibrating Compass Readings
l
Digital Compass Reading Precautions
l
Q5
Readings at the same location
produce different results.
Cannot take readings indoors.
Move away from any potential source of
strong magnetism and try taking a reading
again.
Digital Compass Reading Precautions
l
Watch Operation Guide 3553
Barometric Pressure
Measurement
Q1
The barometric pressure differential
graphic is not displayed after
barometric pressure measurement.
The barometric pressure differential graphic is
not displayed if the barometric pressure
measurement value exceeds the allowable
measurement range (260hPa to 1,100hPa) or
if the barometric pressure differential exceeds
±10hPa. If [ERR] is displayed, there may be a
problem with the sensor.
Checking the Change Between Two
l
Barometric Pressure Readings
(Barometric Pressure Differential)
Q2
[ERR] appears during measurement.
There may be a problem with the sensor. Try
taking another measurement. If [ERR] keeps
appearing after multiple measurement
attempts, contact a CASIO service center or
your original retailer.
Temperature Measurement
Q1
[ERR] appears during measurement.
There may be a problem with the sensor. Try
taking another measurement. If [ERR] keeps
appearing after multiple measurement
attempts, contact a CASIO service center or
your original retailer.
World Time
Q1
The time for a World Time City is not
correct.
The summer time setting (standard time/
summer time) may be wrong.
Specifying a World Time City
l
Alarm and Hourly Time
Signal
Q1
An alarm does not sound.
Is the watch's battery charged?
Keep the watch exposed to light until it
recharges sufficiently.
Charging
l
Other than the above.
The alarm's settings may not be
configured. Configure the alarm settings.
Configuring Alarm Settings
l
Q2
The hourly time signal does not
sound.
Is the watch's battery charged?
Keep the watch exposed to light until it
recharges sufficiently.
Charging
l
Other than the above.
The hourly time signal may be disabled.
Enable the hourly time signal.
Configuring the Hourly Time Signal
l
Setting
37