Table of Contents
Advertisement
1. GRAPHIC WARNINGS
The line trimmer is a high-speed and fast cutting
power tool. All safety precaution must be
observed to reduce the risk of personal injury. Please
read this manual carefully and become familiar with
the controls before using the unit.
This graphic accompanied by the words of
WARNING or DANGER requires your
attention, to an act which could lead to
SERIOUS INJURY.
READ & UNDERSTAND Operator's Manual
and Safety Manual.
ALWAYS WEAR EYE AND EAR PROTECTION.
Always TURN OFF the engine and make
sure the cutting tool has stopped before
cleaning, removing or adjusting the line.
WARNING! Never modify the Line Trimmer
in any way. Im-proper use of any trimmer
can cause SERIOUS OR FATAL PERSONAL
INJURY.
WARNING! The engine exhaust from this
product contains chemicals that may be a
health risk if inhaled directly.
Specifications, descriptions and illustrative material
in this manual are accurate at the time of publication,
but are subject to change without notice.
Illustrations may include optional equipment and
accessories, and may not include all standard
equipment.
2. SAFETY RULES & PRECAUTIONS
When using the equipment, a few safety
precautions must be observed to avoid injuries and
damage.
Please read the operating instructions and safety
regulations with due care. Keep this manual in a
safe place, so that the information is available at all
times. If you give or sell the unit, please ensure you
hand over the operating instructions and safety regu-
lations. We cannot accept any liability for damage or
accidents which arise from not following
instructions and safety regulations.
4
• When working with the unit, all safety
precautions must be taken.
• Always wear safety goggles and dress
appropriately. Do not wear loose clothing or jewelry
that could become caught in moving parts of the
unit. It is recommended that legs and feet be
covered to protect from flying debris during opera-
tion. Safe, sturdy, nonskid footwear should be worn.
Long hair should be tied back.
• Inspect the entire machine for loose parts (nuts,
bolts, screws, etc.) and any damage. Repair or
replace as necessary before using the machine.
• Keep the handles free from oil and fuel. Always use
proper handles and shoulder strap when cutting.
• Do not smoke while mixing fuel or filling tank and
DO NOT mix fuel in an enclosed room or near open
flames. Assure adequate ventilation. Always mix and
store the fuel in a properly marked container that is
approved by local codes and ordinances for such
usage.
• Do not remove the fuel tank cap while the engine is
running and never start or run the unit inside a closed
room or building. Fumes from the exhaust contain
dangerous carbon monoxide.
• Do not make engine adjustments while the unit is
running and or strapped to an operator. Always make
engine adjustments with the unit resting on a flat,
clear surface.
• Do not use the unit if it is damaged or poorly
adjusted. Never remove the machine's guard as
this could result in serious injury to the operator or
bystanders as well as damage to the unit.
•Inspect the area and remove all debris that could be
entangled in the nylon cutting head before cutting.
• Keep children and onlookers away at a safe
distance from the working area. We recommend at
least 15 meters (50 FEET).
• Never leave the machine unattended.
• Do not overreach. Keep proper footing and balance
at all times. Do not run the unit while standing on a
ladder or on any other unstable footing location.
Advertisement
Table of Contents
