Reinstalling The Oven Door; Adjusting The Door Alignment For Side Hinge Doors - Thermador Masterpiece MEDS301BS Installation Manual

Requirements
You have verified the cabinet dimensions and electrical
¡
connections.
You have removed the oven door.
¡
→ "Removing the oven door from bottom hinge
conventional ovens", Page 20
You have read the lifting recommendations → Page 17 .
¡
Position the unit on its packaging base close to and in
1.
front of the cabinet opening.
Lift or slide the unit into the cabinet cutout. Do not allow
2.
the unit base to contact the flooring.
Guide the unit straight back into the cabinet cutout.
3.
Push the unit straight in until the oven trim is about 2"
(5 cm) from being flush with cabinet wall.
Check that the electrical conduit cable is not crimped
4.
between the oven and the cabinet back wall. If
necessary, guide the electric conduit cable into the wall
of the cabinet access hole so it does not prevent the
unit from being pushed all the way into the cabinet
opening.
Check that the oven is straight and level.
5.
Push the unit all the way back into the cabinet cutout
6.
until the front edge of the unit is flush with the front of
the cabinet.
Install the supplied screws through the tap holes in the
7.
trim.
Refer to the enclosed SCREW INSTALLATION leaflet.
8.1 Reinstalling the oven door
Hold the door firmly in both hands. Grip it on either side,
1.
not by the handle.
Tilt the door back slightly towards you at an angle that
2.
would open the door about 7" (18 cm) at the top.
Slide the hinges into the slots
3.
and lower the door straight down
The angle of the door may need to be adjusted slightly
to allow the hinges to engage properly and the door to
be lowered into place. The door should lower about 3/4"
(2 cm) and stop. If it does not, the hinges have not
engaged properly and the door could fall if it is released.
as far as they will go
⁠ .
Installing the ovens into the cabinet en-us
Once both hinges are fully engaged, gently open the
4.
door until it is fully open.
Push the levers on both the hinges up and forward until
5.
they are locked into the slot and flush with the front of
the oven body.
Close and open the door slowly to be sure it is correctly
6.
and securely in place.
8.2 Adjusting the door alignment for side
hinge doors
When the unit is fully installed into the cabinet, you can
adjust the alignment of the side hinge oven doors.
Check to see if the oven doors are properly aligned.
1.
– Examine the gap between the top of the closed oven
door and the control panel. For double ovens also
examine the gap between the top of the closed lower
oven door and the upper oven door. It should be fairly
uniform from side to side.
– The door should pull itself closed smoothly when the
striker engages the roller as the door is closed.
– If you feel interference between the striker and the
catch receiver, the door is too high. The door needs
to move down on the latch side.
– If you feel a bump when the striker comes into
contact with the realignment roller, the door is too
low. The door needs to move up on the latch side.
Open the door to approximately 135°.
2.
25