Hooking Up Your Xm301 Modem.2; Loading The Xe Term Program.2 - Atari XM301 Owner's Manual

HOOKING UP YOUR XM301 MODEM
Hooking up your modem is easy. Follow these steps to connect
your XM301 Modem to your ATARI Personal Computer System:
1. Turn off the power to all components of your computer system.
2. Plug the modem's interface cable into one of the jacks marked
I/O CONNECTORS on the back of your disk drive or printer.
Note:
The modem must be the last component in the daisy chain
of components.
Disk Drive
Modem
niiiiiiiiiiiiiiiniir
uumpuici
T.
1
ain
P
■ IfflB Ml
1 ITmi |fe=r)(=)| a mao a j|
Wall
Jack
j
1
_J
Telephone
Interface Cable
Cord
3. Plug one end of the telephone cord into the phone jack on the
back of your XM301 Modem and the other end into a telephone
wall jack.
Your XM301 Modem is now ready to be used with the XE Term pro¬
gram. When you load the XE Term program, you'll be ready to
communicate with other computers and information systems.
LOADING THE XE TERM PROGRAM
Your XE Term program is on a self booting disk. The new ATARI
DOS 2.5 is resident on the disk, so you can start your ATARI
System without having to use a DOS Master Disk.
Follow these steps to load the XE Term program:
1. Turn on your television or monitor and your disk drive. (Make
sure that there is no cartridge in your computer and no disk in the
disk drive.) The BUSY light on the disk drive goes on for a few
seconds.
Caution:
Never insert or remove a disk in your disk drive while the
drive's BUSY light is on.
2