Leaving Xe Term; Returning To Xe Term.6 - Atari XM301 Owner's Manual

Buffer size: 14752
When you are using the XE Term program, it automatically sets
aside a special area in memory called a buffer for use with the
Capture Text and Upload Text functions. The size of that buffer (in
bytes) is printed at the top of the screen. When you use either
function, the buffer size reappears at screen top, and is updated
so that you're always aware of the remaining free buffer space. If
you're capturing text and the number shrinks below 1000 bytes,
it's a good idea to save your text and clear the buffer before
continuing.
LEAVING XE TERM
There are two ways to exit from the XE Term program.
If you do not want to use DOS, follow these instructions:
1.
Go to the Functions Menu. If you are online, press
[SelectT
otherwise press
[Return],
2. Turn off your computer and remove the XE Term Program Disk
from the disk drive.
If you want to use DOS, follow these instructions:
1. Go to the Functions Menu. If you are online, press
[SelectT
otherwise press
[Return],
2. Press
Q
(Quit to DOS).
The screen prompts:
Sure (Y/N)?
3.
Press
Y.
The screen displays the ATARI DOS 2.5 Menu.
You may then use the DOS commands or exit DOS by turninq off
the computer.
RETURNING TO XE TERM
If you want to return to XE Term after you are finished using DOS:
1. Turn off your computer.
2. Make sure the XE Term Program Disk is still in Drive 1.
3. Reload the XE Term program by turning on your computer
again.
6