Page 3
TAMPERE Traditional Sauna Due to our continued product improvement, product illustrated on this instruction manual may vary slightly from the actual product.
Page 4
RECOMMENDATIONS Read this manual carefully before using your sauna for the first time. We recommend you keep it in a safe place for future reference. • Wood is a living element, to maintain its original appearance, it is important to treat the outside of the wood against moisture.
Page 5
SAFETY IMPORTANT : Please read the safety instructions carefully before installing and using your sauna cabin. They are essential for your safety, so please adhere strictly to them. Beware of hyperthermia, heat stroke or heat exhaustion which can be caused or aggravated by noncompliance with the safety instructions.
Page 8
TAMPERE TRADITIONAL SAUNA Read the assembly instructions carefully before starting. Choice of location Designed solely for exterior installation. Select a space: • In a dry area, on a flat stable surface that can support the weight of your sauna. • The height must be sufficient for you to reach the ceiling and carry out electrical connections and maintenance.
Page 10
ASSEMBLY INSTRUCTIONS Take out the base plate and place it on a flat ground for installation Rear panel Take out the rear panel and stand it at the corresponding position behind the base plate Baseplate...
Page 11
ASSEMBLE INSTRUCTIONS ASSEMBLY INSTRUCTIONS Assemble steps Install the left and ride side panels: The left and right side panels are fixed to the rear panel through a buckle connection. Outer buckle installation method...
Page 12
ASSEMBLY INSTRUCTIONS Assemble steps Install the front panel: The front panel is connected to the left and right side panels through concealed buckles. Hanging buckle installation method Install the internal seat and backrest: The seat is directly fixed by the wall panel support, and the back is fixed by locking screws;...
Page 13
ASSEMBLY INSTRUCTIONS Assemble steps Install the sauna stove protection frame Ø 4 x 30 12PCS Place the sauna stove: Place the stove frame near the right side panel, and then place the sauna stove inside the stove frame; Sauna stove 4 5 6 Cable (3*2.5mm2)
Page 14
ASSEMBLY INSTRUCTIONS Assemble steps Install the top plate Ø 4 x 50 3PCS Schematic diagram of the top switch power box and stove wiring:...
Page 15
ASSEMBLY INSTRUCTIONS Assemble steps Finally, install the handle to complete the installation of the entire machine.
ASSEMBLE INSTRUCTIONS Timer switch Thermostat switch 1. Heater Turn the timer switch to the “ON” section (Section A in figure 2, 0-4 hours). The heater starts heating immediately. TIME (TIMED SWITCH-ON): 2. Pre-setting Turn the timer switch to the “PRE-SETTING” section (Section B in figure 2, 0-hours).
SAUNA MAINTENANCE Protection of wood Brush each exterior barrel slat and apply a wood stain when full assembly to protect the wood. This wood stain had to be renewed according to the recommendations of the product used Maintenance IMPORTANT : Disconnect the cabin’s power supply cable before undertaking any work.