Advertisement
Protection of wood
Brush each exterior barrel slat and apply a wood stain when full assembly to protect the wood.
This wood stain had to be renewed according to the recommendations of the product used
Maintenance
IMPORTANT :
Disconnect the cabin's power supply cable before undertaking any work.
Problems identified
Electric stove does not heat up.
Sauna light fitting no longer
work.
Servicing :
1. Disconnect your sauna.
2. Use a vacuum cleaner to remove dust from crevices in the woodwork.
3. Clean the cabin with a damp cotton cloth and use a small amount of soap if necessary. Rinse with a damp cloth.
4. Clean the glass with a window / glass cleaner and a soft colth.
5. Maintain the exterior of the sauna every 2 years with a suitable product.
IMPORTANT :
•
The wood should be treated with a protective product only on the outside of the sauna.
•
No treatment should be applied inside the sauna.
•
Do not use benzene, alcohol, chemical agents or strong detergents on the sauna since chemical products can damage the wood.
•
Do not spray water on your sauna.
•
Please read the instructions provided with the sauna stove for the installation and use of the stove.
•
The heater may only be connected to the electrical network in accordance with the current regulations by an authorised,
professional electrician.
SAUNA MAINTENANCE
Possible reasons
Power supply cable disconnected. Check power supply cable connection.
The general power supply is cut.
Stove is overheat protected.
Light cable not fully plug.
Light is defective.
Solutions
Check that the switchboard
and wall plug are working
Refer to the electric stove manual.
Plug the cable.
Contact your dealer.
Advertisement
