Table of Contents
Advertisement
32
en | Configuration
–
–
Backlight compensation
–
–
Intelligent Defog
With the Intelligent Defog mode feature, visibility can be improved significantly when
viewing foggy or other low-contrast scenes.
–
–
Sharpness level
The slider adjusts the sharpness level between -15 and +15. The zero position of the slider
corresponds to the factory default level.
A low (negative) value makes the picture less sharp. Increasing sharpness brings out more
detail. Extra sharpness can enhance the details of license plates, facial features and the
edges of certain surfaces but will increase bandwidth requirements.
Temporal noise filtering
Adjusts the Temporal noise filtering level between -15 and +15. The higher the value, the
more noise filtering.
Spatial noise filtering
Adjusts the Spatial noise filtering level between -15 and +15. The higher the value, the
more noise filtering.
5.4.7
Encoder Streams
When this menu is accessed while the device is recording, the following message appears at
the top of the page: "Recording is currently active. At 'Active profile' the stream profile used
for recording is displayed, and overrules the 'Non-recording profile'."
Stream limits (H.264/H.265)
In the dropdown, select the maximum stream resolution as provided per stream.
Stream limits is a mandatory selection to pre-assign the maximum available resolution for
each of the H.264 / H.265 streams. If a lower resolution is selected, you will be more
flexible in streaming options on the second stream.
Stream prioritization
Select the stream that should not drop any frame.
Coding standard
Select the coding standard you want to use for the stream.
Active profile
Active profile shows the profile that is in use and can be set differently per stream
If no edge recording or VRM recording is active, the device switches to the Non-recording
profile. Please refer to section Non-recording profile.
(Only applicable to 2MP models)
2023-11 | V01 | F.01U.408.367
Optimized DR - Select this mode for scenes with greater dynamic range requirements.
Extreme DR - Further increases performance at an even greater HDR ratio. Due to the
increased HDR ratio, there is a greater risk of HDR artifacts in the scene and on moving
objects.
Select Off to switch off backlight compensation.
Select On to capture details in high-contrast and extremely bright-dark conditions.
Select Auto to activate the Intelligent Defog feature automatically as needed.
Select Off to disable the feature.
User manual
FLEXIDOME micro 3100i
Bosch Security Systems B.V.
Advertisement
Table of Contents
