Installing Your Wine Cellar - Vinotemp VT-12TEDI Owner's Manual

INSTALLATION INSTRUCTIONS
Before using your wine cellar
• Remove the exterior and interior packing
• Check to be sure the following parts are included:
o For VT-12TEDi, 3 Slide out shelves
o 1 Instruction manual
• Before connecting the appliance to the power source, let it stand upright
for approximately 2 hours. This will reduce the possibility of a malfunction
in the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.

INSTALLING YOUR WINE CELLAR

• Place your appliance on a floor that is strong enough to support the
appliance when it is fully loaded. To level your appliance, adjust the front
legs at the bottom of the appliance.
• Unit must be placed as a freestanding unit—not to be built in.
• For proper installation, keep away from direct sunlight and sources of
heat (stove, heater, radiator, etc.). Direct sunlight may affect the
coating and heat sources may increase electrical consumption. Extreme
cold or hot ambient temperatures may also cause the appliances not to
perform properly.
• Not designed for placement in garage or basement. Designed for use
inside the home.
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
9