Marantz MR2020 User Manual page 5

Compact disc player tuner amplifier
Hide thumbs Also See for MR2020:
Table of Contents

Advertisement

Available languages

Available languages

Foreword
This section must be read before any connection is made to the
mains supply.
WARNINGS
Do not expose the equipment to rain or moisture.
Do not remove the cover from the equipment.
Do not push anything inside the equipment through the
ventilation holes.
Do not handle the mains lead with wet hands.
Equipment mains working setting
Your Marantz product has been prepared to comply with the house-
hold power and safety requirements that exist in your area. "/2A,/
2B" Version product can be powered by 230 V AC only. On the rear
panel of the "K" Version product, a voltage selector (2-position) is
provided. Be sure to set the voitage selector to the mains voltage of
your area before using the unit.
Important:
This apparatus is fitted with an approved molded 13 Amp plug. To
change a fuse in this type of plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fix new fuse which should be a BS1362 5A, A.S.T.A. or BSI
approved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place. If the mains plug
contains a fuse, this should have a value of 5A. If a plug without a
fuse is used, the fuse at the distribution board should not be greater
than 5A.
Note:
The severed plug must be destroyed to avoid a possible shock haz-
ard should it be inserted into a 13A socket elsewhere.
How to connect a plug
The wires in the mains lead are colored in accordance with the
following code:
BLUE — "NEUTRAL" ("N"}
BROWN -— "LIVE"("L")
1. The BLUE wire must be connected to the terminal which is
marked with the letter "N" or colored BLACK.
2. The BROWN wire must be connected to the terminal which is
marked with the letter "L" or colored RED.
3. Do not connect either wires to the earth terminal in the plug
which is marked by the letter "E" or by the safety earth symbol
or colored green or green-and-yellow.
Before replacing the plug cover, make certain that the cord grip is
clamped over the sheath of the lead — not simply over the two wires.
Copyright
Recording and playback of any material may require consent. For
further information refer to the following:
~ Copyright Act 1956
— Dramatic and Musical Performers Act 1958
— Performers Protection Acts 1963 and 1972
— any subsequent statutory enactments and orders
Precautions
The following precautions should be taken when operating the equip-
ment.
General precautions
When setting the equipment ensure that:
— the ventilation holes are not covered
— air is allowed to circulate freely around the equipment
— itis on a vibration free-surface
— it will not be exposed to interference from an external source
— it will not be exposed to excessive heat, cold, moisture or dust
— it will not be exposed to direct sunlight
— it will not be exposed to electrostatic discharges.
Never place heavy objects on the equipment.
If a foreign body or water does enter the equipment, contact your
nearest dealer or service center. Do not pull out the plug by pulling
on the mains lead, hold the plug. It is advisable when leaving the
house, or during a thunderstorm, to disconnect the equipment from
the mains supply.
ENGLISH

Advertisement

Chapters

Table of Contents
loading

Table of Contents