Assembly Instructions - Salus Gothenburg II Owner's Manual

Assembly Instructions

1. Place Bottom Support Cradles
Place the bottom support cradles at their desired locations. See figure 1. Determine
the front and rear positions of the support cradle according to the marks on the floor.
The 2-person model will have (3) support cradles. The 4-person model will have (3)
support cradles. The 6-person model will have (4) support cradles. See figure 1a. To
avoid damaging your floor, it is not recommended to move the sauna once it is
assembled. If the unit is moved, please do so carefully and cautiously.
a. Make sure there is a power outlet within reach of the power cord before
assembling the barrel sauna. The light will require a 120V/15AMP outlet.
b. Make sure to position the front door in the correct direction.
2-Person Model
Gothenburg II
2. Fix Bottom Support Cradles
Locate the two end staves with pre-drilled holes for the installation of the first stave.
The first stave will have the drain holes. Place the first of the three staves (the one with
the drain holes) on top of the support cradles. The end support cradles will have a
sticker indicating where the first stave will screw to the cradle. Once the stave is
placed into position onto the support cradles, you can use the provided two M4*50
stainless steel screws to mount the stave to the support cradles. See the Components
4-Person Model
Uppsala II
23
6-Person Model
Marstrand II