Salus Gothenburg II Owner's Manual page 28

Adjust front panel to be level. Front panel must fit into
figure 6b
7. After Placing Front Panel Onto Platform
You can use one of the staves to hold the front and the rear panels in place. Make
sure the groove on each end of the stave fits onto the front and rear to hold them
stationary in place. This is a temporary step to hold the front and rear panels in place.
You can use a stave to also help to hold the front panel and rear panel in place.
One adult will need to continue to hold the front panel in place. Do not
nail/screw this stave down. See figure 7.
figure 7
8. Install the Staves
Continue to install and align the two ends of the staves onto the front and rear working
your way upward. Carefully and accurately place them onto the front and rear. Use
the leveler and mallet to make sure that each stave is placed level and straight. Do not
allow excessive gaps in between the staves. Attach the stave using the provided
th
stainless steel nails from the exterior starting from the 9 stave (not counting the first
st st
installed stave) in every other stave through the 21 stave. From the 21 stave, do
not nail in any additional staves. The nails are used to mount and keep the staves
aligned and straight. Be sure to use a hammer (not the included mallet) when
hammering the stainless steel nails. See figure 8.
28