Salus Gothenburg II Owner's Manual page 32

Model Marstrand II
figure 12a
13. Install Bench Panel
Start with the left side. Place the bench panel into position over the horizontal beam. Use the
two/four screws (depending on model) to mount the bench into place. See figure 13. Do the
same for the right side.
figure 13
14. Install Backrest
Start with the left side. Place the backrest into position using the leveler to make sure that it is
level. The bottom of the backrest will sit above the bench. Use the (2) screws to mount the
backrest into place. You will need to connect the connection for the lights. See figure 14 &
14a. Follow the same steps for the right side. The power cord can be ran through the rear
wall panel to be connected to a 120V/ 15AMP outlet.
Gothenburg II
Uppsala II
Marstrand II
(top) (bottom)
Mounted on the backside of the bench front wood plank
figure 14
32
Gothenburg II
Uppsala II
Marstrand II
(top) (bottom)
M4*50 =4pcs each bench
Stainless Steel Screws