Naming Preset Stations And Inputs - Sony HT-DDW670 Operating Instructions Manual

You
call ellter a ilanle of up to
8 characters for
preset stations and inputs selected with input
buttons, and display it ill the receiver's display.
1
To index a preset station
Press FM or AM to select the FM or AM
band, then tune in the preset station
you want to create an index name for
(page 21).
To index an input
Press the input button to select the input
you want to create an index name for.
2 Press MAIN MENU repeatedly to select
"<CUSTOM >%
3
Press < or > repeatedly to select
"NAME IN".
4
5
6
Press ENTER.
The cursor llashes and you call select a
character.
Use < or > and + or - to create an
index name.
Press + or repeatedly to select a character,
then press > to move the cursor to the next
position.
Tips
• You can select the character type as follm_s by
pressing + or repeatedly.
Alphabet (upper case) --+ Numbers --+ Symbols
• To enter a blank space, press + or repeatedly
until a blank space appears in the display.
• if you made a mistake, press < or > repeatedly
until the character you want to change flashes,
then press + or repeatedly to select the correct
character.
Press ENTER to store the index name.
Note (Models of area code CEL, CEK only)
When you name an RDS station and tune in tile station,
the Program Service name appears instead of file name
you entered./You cannot change the name of a
Program Service name. The name you entered will be
over_ ritten by tile Program Service name.)
32 G8
You can set tile receiver to turn off automatically
at a specified time. Use the remote lor the
operation.
Press SLEEP while the power is on.
Each time you press SLEEP, the display changes
cyclically as follows:
2-00-00 ---+ 1-30-00 ---+ 1-00-00 ---+
0-30-00 --+ OFF
While using Sleep Timer. "SLEEP" lights up ill
the display.
Tip
To check the remaining time before the receiver turns
off, press SLEEP. The remaining time appears in tile
display, lfyou press SLEEP again, file sleep timer will
be canceled.