Sony HT-DDW670 Operating Instructions Manual page 39

The FM reception is poor.
• Use a 75-ohm
coaxial cable (not supplied) to
connect tile receiver to an outdoor FM antenna as
shown below. If you connect tile receiver to an
outdoor antenna, ground it against lighming. To
prevent a gas explosion, do not connect the ground
wire to a gas pipe.
Outdoor FM antenna
Receiver
Ground wire
(not supplied)
To ground
Radio stations cannot be tuned in.
•
Check that the antennas are connected
securely.
A(liust tile antennas and connect an external
antenna if necessary.
• The signal strength of the stations is too weak
(when tuning in with automatic tuning). Use direct
tuning.
• Make sure you set the tuning interx al correctly
(when tuning in AM stations with direct tuning).
• No stations have been preset or the preset stations
ha; e been cleared (when tuning by scanning
preset stations). Preset the stations (page 211).
• Press DISPLAY repeatedly so that the frequency
appears in the display.
RDS does not work.'
• Make sure that you are tuned to an FM RDS
station.
• Select a stronger FM station.
The RDS information that you want does not
appear?
• Contact the radio stat ion and find out _qlether they
actually provide the service in question. If so, the
service may be temporarily out of order.
• Models of area code CEL CEK only.
Remote control
The remote does not function.
Point the remote at the remote sensor _{_on Ihe
receiver.
Remove any obstacles in tile path between the
remote and tile receiver.
Replace all tile batteries in the remote with new
ones, if they are weak.
Make sure you select the correct input on the
remote.
To activate the buttons with orange printing, press
TV and the button you want simultaneously.
Before you use the tl,/tF/_./_ button for receiver
operation, press MAIN MEN U. To operate other
components, press TOP MENUYGUIDE or AV
MENU after pressing the input button.
Error messages
11 there is u malfunclion,
lhe display shows u _>
message. You can check the condition of the o.
receiver by the message. Refer to the lk)llowing _;
table to solve the problem. _"
DEC. EROR
Appears when tile signal which file receiver cannot _"
decode (ex. DTS-CD) is input when "DEC. XXXX"
is set to "DEC. PCM'. Set to "DEC. AUTO".
PROTECT _"
.-t
Irregular current is output from the speakers. The
receiver will automatically turn off after a few
seconds. Check the speaker connection and turn on
the power again. If this problem persists, consult
your nearest Sony dealer.
continued
3gGB