Listening To Fm/Am Radio - Sony HT-DDW670 Operating Instructions Manual

You can listen to FM aud AM broadcasts
through the built-in tuner. Before operatitm.
make sure you have ctmnected the FM and AM
antennas to the receiver (see page 10).
Tip
The tuning scale dilli:rs depending on Ihe area code as
shown in tile fi)llowing table. For details on area codes,
see page 3.
Area code FM AM
U, CA Ill0 kHz 10 kHz*
CEL, CEK, SP, AU 50 kHz 9 kHz
MX 50 kHz I0 kHz
E51 5//kHz 10 kHz:'-
L, The AM tuning scale can be changed (see page 41/.
Automatic tuning
If you do 11olkuow the l)'equency ollhe slation
you waul, you can lel the receiver scau all
available slatious in your area.
1
Press FM or AM to select the FM or AM
band.
The lasl received slalion is luned in.
2
Press TUNING + or TUNING-.
Press TUNING + to scan from low lo high;
press TUNING - lo scan from high lo low.
The receiver slops scanuing whenever a
slaliou is received.
Tip
If _STEREO" flashes in the display and the FM stereo
reception is poor, press FM MODE to change to
monaural (MONO). You will not be able to et\ioy the
stereo effect, but the sound will be less distorted. To
return to stereo mode, press FM MODE again.
Direct tuning
You can euter the fi'equeucy of the station you
waut directly. Use the remote liar the operatiou.
1
Press TUNER repeatedly to select the
FM or AM band.
The last received statitm is tuued iu.
2
3
Tip
You can also use FM or AN] on Ihe receiver.
Press D.TUNING.
Press the numeric buttons to enter the
frequency.
Exmnple 1: FM 102.50 MHz
Press 1 *- 0 ,_-2 ,_-5 ,_-0
Example 2: AM 1,350 kHz
Press 1 *- 3 ,_-5 ,_-(t
(You do not have to enter the last "0" when
the tuniug scale is set to I0 kHz.)
If you have tuned in an AM slatiou, adjusl
the direction of the AM loop auteuna for
optimum receplitm.
If you cannot tune in a station
and the entered numbers flash
Make sure you have entered the right frequency.
11 not. repeat steps 2 and 3. If the entered
tmmbers still flash, lhe frequency is uol used in
your area.
3
"o
m n,
O
"o
I gG8