Table of Contents
Advertisement
Maintenance
3.
Replace thigh pad.
4.
Drive the machine and check the full forward
tracking.
5.
Repeat steps 1 through 4 until desired tracking
is obtained.
Note: The motion control lever needs to be in
neutral while making any necessary adjustments.
Motion Control Neutral Lock
Adjustment
There is a plate under the control panel that engages
notches in the motion controls when the brake is
applied in neutral. If the parking brake plate tabs do
not engage these notches, adjust the front control
links.
1.
Slowly apply the brake while observing the tabs
of the brake plate engaging the notches in the
motion controls. The lock plate should drop
easily and freely into the notches on each side.
2.
Check that controls are in neutral. Adjust each
side via the front control link (see Figure 33).
1. Link
3.
Remove the thigh pad.
Figure 33
2. Jam nut
4.
Loosen upper and lower jam nuts at the top of
the front control link.
A.
Lengthen link to move control rearward.
B.
Shorten link to move control forward.
5.
Partially cycle brake on and off to observe plate
movement in and out of notch.
6.
Tighten jam nuts.
7.
Replace thigh pad.
8.
Check full forward tracking.
g446989
52
Advertisement
Table of Contents
