Siemens SIMATIC NET RUGGEDCOM RX1512 Equipment Manual page 27

Device Management
3.1 Connecting to the Device
Serial Console and Management Ports
Connect a workstation directly to the serial console or management ports to access
the boot-time control and RUGGEDCOM RX1512 interfaces. The serial console port
provides access to RUGGEDCOM RX1512's console interface, while the management
port provides access to RUGGEDCOM RX1512's console and Web interfaces.
Connection to the console port is made using an RJ-45-to-DB9 console cable. The
following is the pin-out for the console port:
8
Figure 3.2
a
The DSR, DCD and DTR pins are connected together internally.
b
The CTS and RTS pins are connected together internally.
c
RI is not connected.
For information about how to connect to the device via the serial console port, refer
to the "RUGGEDCOM ROX II CLI Configuration Manual" for the RUGGEDCOM RX1512.
For information about how to connect to the device via the management port,
refer to either the "RUGGEDCOM ROX II Web Interface Configuration Manual" or the
"RUGGEDCOM ROX II CLI Configuration Manual" for the RUGGEDCOM RX1512.
The management port is a 10/100Base-TX copper Ethernet port with an RJ-45
connector. The following is the pin-out for the management port:
8
Figure 3.3
18
1
RJ-45 Console Port Pin Configuration
Pin
RJ-45 Male DB9 Female
1
2
3
4
5
6
7
8
1
RJ-45 Management Port
Pin
1
Name
a
6 DSR
1
a
4 DTR
5 GND
2 RxD
3 TxD
b
8 CTS
b
7 RTS
c
9 RI
Name
RX+
Description
Data Set Ready
Reserved (Do Not Connect)
Data Terminal Ready
Signal Ground
Receive Data (to DTE)
Transmit Data (from DTE)
Clear to Send
Request to Send
Ring Indicator
Description
Receive Data+
Equipment Manual, 10/2023, C79000-G8976-1057-25
RUGGEDCOM RX1512