Advertisement
EN
equipped with these anchors although they are
standard on more recent models.
Your child in the Mica 360 Pro i-Size car
seat
• The newborn inlay included in your Mica 360
Pro i-Size seat is exclusively for use with the
Mica 360 Pro i-Size and plays an integral part in
the safety of the restraint system for your child
from 40 to 60 cm. The newborn inlay is
removable, and the cover can be taken off for
washing; it is essential to place it back again
where it belongs and only use this official
Maxi-Cosi Mica 360 Pro i-Size newborn inlay.
• Make sure you can fit no more than one finger
between the harnesses and your child (1cm).
If there is more space than 1 cm, tighten the
harness belt further.
• Make sure the headrest is adjusted to the
proper height.
WARNING:
• When using Mica 360 Pro i-Size in a
rearward-facing position it is mandatory to use
the maximum recline position for a child up to
75 cm.
• Never allow your child to climb in and out of
the car seat when the Mica 360 Pro is in the
slide out position.
• The car seat must always be locked in the
forward facing or rearward facing position
when travelling. Do NOT travel when the car
I
85
Mica 360 Pro i-Size 40 cm-105 cm / 18 kg
I
Maxi-Cosi
seat is rotated to a lateral (loading) position or
to any other unlocked intermediate position.
• It is prohibited to adjust the seat position
while travelling.
• When installing the car seat, spaces between
the base of the car seat and the vehicle seat are
possible depending on the position of the
anchorage points in the vehicle.
• If you use the Mica 360 Pro i-Size on the front
seat, it is mandatory to deactivate the airbag of
the seat in question and move the passenger
seat back to a maximum (Please consult your
car manual).
CARE
The cover, headrest cover, shoulder pads, lap
pads and the newborn inlay can be removed for
washing. If the cover needs to be replaced at
any time, only use official Maxi-Cosi covers
because it constitutes an integral part of the
restraint performance.
Advertisement
