Hill Start Assist Warning Light/Hill Start Assist Off Indicator Light; Cruise Control (If Equipped) - Subaru Crosstrek 2020 Manual

7-50
Starting and operating/Cruise control
5. Press and hold the Vehicle Dynamics
Control OFF switch for 30 seconds until
the Vehicle Dynamics Control OFF indica-
tor light on the combination meter turns
on and off.
6. Within 5 seconds, release the Vehicle
Dynamics Control OFF switch.
7. Within 2 seconds, press back the
Vehicle Dynamics Control OFF switch.
The Hill start assist OFF indicator light
turns on and off.
8. Turn the ignition switch to the "LOCK"/
"OFF" position. Hill start assist is deacti-
vated.
NOTE
When the Hill start assist system is
deactivated, the Hill start assist OFF
indicator light illuminates.
! To reactivate
To reactivate Hill start assist system,
repeat steps 1 to 8. When the Hill start
assist system is activated, the Hill start
assist OFF indicator light turns off.
& Hill start assist warning light/
Hill start assist OFF indicator
light
Refer to "Hill start assist warning light/Hill
start assist OFF indicator light" F3-22.

Cruise control (if equipped)

NOTE
For models with EyeSight system:
Refer to the Owner's Manual supple-
ment for the EyeSight system.
Cruise control enables you to maintain a
constant vehicle speed without holding
your foot on the accelerator pedal and it is
operative when the vehicle speed is 20
mph (30 km/h) or more.
WARNING
. Do not use the cruise control
under any of the following condi-
tions. These may cause loss of
vehicle control.
– Driving up or down a steep
grade
– Driving on slippery or winding
roads
– Driving in heavy traffic
– Towing a trailer
. When using the cruise control,
always set the speed appropri-
ately according to the speed limit,
traffic flow, road conditions, and
other conditions.