Operating Conditions - Subaru Crosstrek 2020 Manual

cancel the system, refer to "Cancel-
ing the Reverse Automatic Braking
system operation" F7-78.
& Operating conditions
The Reverse Automatic Braking system
will operate when all of the following
conditions are met.
1) EyeSight warning indicator
2) RAB warning indicator
3) RAB OFF indicator
. The ignition switch is in the "ON"
position.
. The EyeSight warning indicator is off.
. The RAB warning indicator is off.
. The RAB OFF indicator is off.
. The Reverse Automatic Braking sys-
Starting and operating/Reverse Automatic Braking System
tem is set to on.
. The select lever is in the "R" position.
. The vehicle speed is between 1 to 9
mph (1.5 to 15 km/h).
NOTE
. In the following cases, the Reverse
Automatic Braking system will not
operate. Promptly contact a SUBARU
dealer to have the system inspected.
– The EyeSight warning indicator
is illuminated.
– The Reverse Automatic Braking
fail indicator is illuminated.
. When the Reverse Automatic Brak-
ing system OFF indicator is illumi-
nated, the Reverse Automatic braking
system cannot be operated.
. In the following cases, the system
may not be able to properly detect an
obstacle. Promptly contact a SUBARU
dealer to have the system inspected.
– A sticker, paint, or a chemical is
applied to the sonar sensor or the
rear bumper near the sonar sensor.
– The rear bumper is modified.
– The rear bumper has been re-
moved and reattached.
– The ground clearance is changed
due to the vehicle's loading condi-
tion or modification.
– The sonar sensor and the area
near the sonar sensor are being
damaged.
– The rear bumper is exposed to
strong impact, or the rear bumper is
deformed.
. When the 8-inch audio/navigation
system is performing a software up-
date, the Reverse Automatic Braking
System may not display the following
items on the audio/navigation screen
until the update is complete.
– Display Icon on/off Function
– Distance Indicator Image
– Warning Message
. On a steep hill, the system's auto-
matic braking ability will be reduced.
. The system is designed to avoid
collisions by automatic hard braking
when the vehicle's reversing speed is
less than approximately 3 mph (5 km/h).
However, the system does not guaran-
tee that the vehicle will be able to avoid
collisions in any situation.
. If the vehicle is reversed at an
extremely slow speed, the driver's
operation may be prioritized. In this
case, automatic braking will not oper-
ate.
. The system may not be able to detect
the following objects.
– Sharp or thin objects such as
poles, fences and ropes which may
– CONTINUED –
7-73