Subaru Crosstrek 2020 Manual page 110

2-4
Keys and doors/Keyless access with push-button start system
. The keyless access with push-
button start system uses radio
waves of the following fre-
quency* in addition to the radio
waves used for the remote key-
less entry system. The radio
waves are periodically output
from the antennas installed on
the vehicle as shown in the
following illustrations.
* Radio frequency: 134 kHz
1) Antenna
CAUTION
. Never leave or store the access
key fob inside the vehicle or
within 6.6 ft (2 m) around the
vehicle (e.g., in the garage). The
access key fob may be locked
inside the vehicle, or the battery
may discharge rapidly. Note that
the push-button ignition switch
may not turn on in some cases
depending on the location of the
access key fob.
. The access key fob contains
electronic components. Observe
the following precautions to pre-
vent malfunctions.
– It is recommended to have the
access key battery replaced at
an authorized SUBARU dealer
to avoid the risk of damage.
– Do not get the access key fob
wet. If the access key fob gets
wet, wipe it off immediately
and let it dry completely.
– Do not apply strong impacts to
the access key fob.
– Never leave the access key
fob in direct sunlight or any-
where that may become hot,
such as on the dashboard. It