Table of Contents
Advertisement
4-7-10.
RD-41 Board
Preparation
1.
Refer to
"4-2. Flow
Chart".
Procedure
1.
Remove the tape (13 x 50), and then disconnect the harness from the connector (CN400) on the RD-41 board.
Note
On assembly, attach the tape over the harness so that the harness stays on the board. (Fig.1)
2.
Remove the screw (PSW2.6 x 5) and the two screws (PSW2.6 x 6 (black)).
3.
Remove the RD-41 board from the three connectors (CN2001, CN2002, CN2003) on the DIO-101 board.
PSW2.6 x 6 (Black)
Tape (13 x 50)
DIO-101 board
CN2003
Fig.1
DIO-101 board
Harness
Tape (13 x 50)
4.
Install the removed parts by reversing the steps of removal.
PWS-4500
PSW2.6 x 5
Connectors
Harness
CN004
CN2001
RD-41 board
RD-41 board
CN2002
4-41
Advertisement
Table of Contents
