Table of Contents
Advertisement
Before presetting your VCR:
® Switch on both the television and your VCR
@ Check that the date and time are correct
@ Insert the cassette on which the programme is to be
recorded (safety tab intact)
Up to six programmes can be preset.
_eeeeesseesreteceecminenaensesocesitt
1
Press the TIMER button.
Result!
The TIMER METHOD is displayed.
2
Press the corresponding 4 or w buttons, until the G- CODE option
is selected.
penta
LS SS
SOO ESC BCE EES
3
Press the » button to select G- CODE.
Result;
A message is displayed to allow you to enter the
G-CODE code.
@
if alt six programmes have been set, the message TIMER
IS
FULL is displayed. Refer to page 29 if you wish to
cancel a preset recording.
4
Press the numeric buttons to enter the code opposite the pro-
gramme that you wish to record in your television magazine.
>
if you wish to correct the G-CODE code that you are
entering:
¢@ Press the < button until the digit to be corrected is
Cleared
@ Enter the correct digit
§
Press the MENU button.
Result:
The information concerning the programme is displayed.
"&
When using the G-CODE function for the first time with
stored stations, the programme number flashes. This one
time, you must enter the station number manually by
pressing the « or w buttons. Refer to the following page if:
The programme number or times flash
@
You wish to modify the programme
6
If the programme and times are correct, press the MENU button.
Press the VCR STANDBY/ON (STANDBY/ON) button to activate
the timer.
Result:
The Timer indicator (@)) is displayed.
®
|fno cassette has been inserted when you press
VCR STANDBY/ON (STANDBY/ON) the Timer indicator
flashes. If the safety tab on the cassette has been broken,
the cassette is ejected. Insert the appropriate cassette,
8 — Refer to page 29 if you wish to:
@
Check that your VCR has been programmed correctly
@
Cancel a preset recording
nace
ER RS
stoners
all The numbers next to each TV porn
listing are
G-CODE code numbers, which
allow you to programme
our videorecorder instantly with the remote control. Tap
in he G-CODE code for the programme you wish to
record.
™ G-CODE is a trademark of Gemstar Development Corporation. The G-CODE system is
manufactured under licence from Gemstar Development Corporation.
Advertisement
Table of Contents
