7 - Control with Control Unit 8 - Control with an External Device 8 - Control with an External Device 9 - Control with the Lode Ergometry Manager (LEM) 9 - Control with the Lode Ergometry Manager (LEM) 10 - Maintenance...
The maintenance and service of the medical device has to be done by a well-trained service engineer who is working for a Lode distributor and is specifically trained regarding the MD by the International Service Coordinator of Lode.
Replacement of the power supply cord should be installed by authorised service personnel, instructions for correct connection and anchoring must be ensured, securing that the requirements of clause 8.11.3 of IEC 60601-1 are met. M934900 - MANUAL KATANA SPORT / VERSION: 1.2 - 2018-10-17 4/22...
Page 5
Replacement of parts can only be done by the manufacturer or designated service personnel. Read this manual before using the device and follow it carefully. M934900 - MANUAL KATANA SPORT / VERSION: 1.2 - 2018-10-17 5/22...
Page 6
This device should only be sold by, or under the supervision of authorized persons. Make sure you always fix the handrails by tightening the spanners on the side handrails before anybody starts using the treadmill. M934900 - MANUAL KATANA SPORT / VERSION: 1.2 - 2018-10-17 6/22...
During the intended use the test subject will deliver energy. Application of the wrong dosis of energy could lead to permanent damage of the test subject health. Only use this device under supervision of a medical physician. M934900 - MANUAL KATANA SPORT / VERSION: 1.2 - 2018-10-17 7/22...
(4). Each treadmill is supplied with a carton box with additional accessories and tools, like the manual, test certificate, safety lanyard and tools for adjustments. M934900 - MANUAL KATANA SPORT / VERSION: 1.2 - 2018-10-17 8/22...
6 - Install your Katana treadmill ergometer 1. While unpacking the Lode treadmill ergometer, leave the transport straps on both ends in place. 2. Place the treadmill in the location where it will be used. 3. Remove Both transport straps and remaining packaging materials.
1. Connect the device with the supplied cable to the external device. You can control the device with e.g. an exercise ECG device or Metabolic Card. 2. Download the interfacing instructions from the internet at www.lode.nl after you have registered your device.
Opening of the equipment by unauthorized agencies is not allowed and will terminate any claim to warranty. Lode will make available on request circuit diagrams, component part lists, descriptions, calibration instructions, or other information that will assist authorized service personnel to repair those parts of the ergometer that are designated by Lode as repairable by authorized service personnel.
Page 12
If you are not certain about the discolouring effect of a cleaning agent, you may try a little on a part of the product that is not visible during normal use. Lode cannot advise a specific cleaning agent, since local recipes may differ. The slats can be cleaned with a dry brush.
European Parliament and of the Council on waste electrical an electronic equipment are necessary to reduce the waste management problems linked to the heavy metals concerned and the flame retardants concerned M934900 - MANUAL KATANA SPORT / VERSION: 1.2 - 2018-10-17 13/22...
Page 14
Tested and certified to U.S. and Canadian National Standards by a NRTL, viz TÜV Rheinland. Compliance for U.S. and Canadian markets. FCC 18 RF ISM tested Safety notes Connector for Control Unit External Control Connector Emergency Stop RS232 Network (Proprietary Lode) M934900 - MANUAL KATANA SPORT / VERSION: 1.2 - 2018-10-17 14/22...
14.1 - Emissions test The Lode equipment is intended for use in the electromagnetic environment specified below. It is the responsibility of the customer or user to ensure that the Lode equipment is used in such an environment. Emissions test: RF emissions CISPR11...
14.2 - Immunity test The Lode equipment is intended for use in the electromagnetic environment specified below. It is the responsibility of the customer or user to ensure that the Lode equipment is used in such an environment. Immunity Test: Electrostatic discharge (ESD) EN 61000-4-2 Immunity Test: IEC 60601-Test Level: ±...
Page 17
The Lode equipment is intended for use in the electromagnetic environment specified below. It is the responsibility of the customer or user to ensure that the Lode equipment is used in such an environment. Immunity test: Conducted RF 61000-4-6 Immunity test:...
Recommended Separation Distances between Portable and Mobile RF Communication Equipment and the Lode equipment The Lode equipment is intended for use in the electromagnetic environment on which radiated RF disturbances are controlled. The customer or the user of the Lode equipment can help prevent...
Possibility of downhill Ultimate safety Flexibility in exercising Flexibility in exercising Extra high speed walking Acceleration & Deceleration Rear Elevation -25% electrical Emergency Stop Button Autospeed Speed 40 km/h Katana sport M934900 - MANUAL KATANA SPORT / VERSION: 1.2 - 2018-10-17 19/22...
Page 20
Partnumber: 945833 Easy connection Easy connection Easy connection Heartrate available within an extreme wide range USB to Serial converter RS232 cable Network module connection Bluetooth Smart heart rate cable M934900 - MANUAL KATANA SPORT / VERSION: 1.2 - 2018-10-17 20/22...
Swedish user interface Turkish user interface Ukrainian user interface Connectivity Lode ERM interface protocol "HP Cosmos" interface protocol "Woodway" interface protocol "Trackmaster" interface protocol "GE" interface protocol USB connector M934900 - MANUAL KATANA SPORT / VERSION: 1.2 - 2018-10-17 21/22...
Page 22
Step up plate emergency stop Certification CE class Im according to MDD93/42/EEC CE class of product with optional SpO2 CE class of product with optional BPM Order info Partnumber 934900 M934900 - MANUAL KATANA SPORT / VERSION: 1.2 - 2018-10-17 22/22...