Table of Contents
Advertisement
<CD mechanism base assembly>
Prior to performing the following procedure, remove
the CD mechanism base assembly.
Removing the speaker terminal board
1
(See Fig.28)
. Remove
the two screws T
attaching the speaker
terminal
board
on
the
underside
of
the
CD
mechanism base assembly.
Removing the CD mechanism board / CD
os
mechanism assembly (See Fig.28 to 32)
. Turn over the CD mechanism
base assembly and
disconnect the harness from connector CN703
and
CN706 on the CD mechanism board.
. Turn over the CD mechanism
base assembly and
disconnect the harness from connector CN703 and
CN706 on the CD mechanism board.
. Turn back the CD mechanism assembly and detach
the CD
mechanism
cover
while
pulling the CD
mechanism
assembly outward
to release the two
joint tabs marked c.
Disconnect the card wire from the connector of the
CD mechanism assembly inside the CD mechanism
cover.
Disconnect the harness from CN605 on the
CD
mechanism
board.
Pull the CD
mechanism
assembly
out
of the
three
shaft
of the
CD
mechanism cover.
ATTENTION: When
reassembling, confirm that the
cushion
of
the
CD
mechanism
assembly
is reattached
to the three
shafts.
Remove
the CD
mechanism
board
from
the CD
mechanism cover.
Shafts
CD mechanism board
Fig.32
CD mechanism cover
FS-SD5R/FS-SD7R/FS-SD9R
CD mechanism board
U
Speaker terminal board
CD mechanism.
cover
CD mechanism assembly
Joint c
CD mechanism cover
Tab
Joint c
Cushion
CD mechanism board
~~
CN706
Fig.28
Tab
CD mechanism cover
Fig.29
CD mechanism assembly
Fig.30
CD mechanism assembly
Cushion
CD mechanism cover
2-7
Advertisement
Table of Contents
