Things To Consider Before You Connect; Protect Against Power Surges; Protect Components From Overheating; Position Cables Properly To Avoid Audio Interference - RCA GUIDE Plus+ F27650 User Manual

Connections S ' up
Things to Consider Before You Connect
Protect Against Power Surges
• Connect all components before you plug any of their power cords into the wall outlet.
• Turn off die TV and/or component belbre you connect or disconnect any cables.
• Make sure all antennas and cables are properly grounded. Refer to the Important
Safeguards sheet packed with your TV.
Protect Components from Overheating
• Don't block ventilation holes on any of the components. Arrange the components so that
air can circulate freely.
• Don't stack components.
• When you place components in a stand, make sure you allow adequate ventilation.
• If you connect an audio receiver or amplifier, place it on the top shelf so the heated air
from it won't flow around other components.
Position Cables Properly to Avoid Audio Interference
• Insert each cable firmly into the designated iack.
• If you place components above the TV, route all cables down the side of the back of the
TV instead of straight down the middle of the back of the TV.
• If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin
lead cables away from audio/video cables.
Important Stand and Base Safety Information
Choose the location for your TV carefully. Place the "1_ on a stand or base that is of adequate
size and slrength to prevent the TV from being accidentally tipped over, pushed off, or pulled
off. This could cause personal injury and/or damage the TV. Refer to the hnportant Safeguards
sheet packed will] your TV.
Use Indirect Light
Don't place the TV where sunlight or room lighting will be directed toward d_e screen. Use sot_
or indirect lighting.
Connection Pictures
Audio/vMeo cables are usually bundled together. For better visibility, the connection pictures in
this book show each cable separately (audio left, audio right, and video).
Demo Pin
You must remove the Demo Pin from the G-LINK iack on the back of
your "IV in order for your TV to operate properly and to connect the
G-LINK cable.
6 Chapter1