Table of Contents
Advertisement
Connections
S ' up
TV(backpanel)
From Cable
or Antelzna
TV + VCR
1.
Connect
your
TV to your
VCR
2.
A. Connect a coaxial cable to the CABLE/ANTENNA iack on your "lW and to the Output Jack on
your VCR (sometimes
labeled OUT TO "lW).
B. Connect the audio/video
cables. Connect audio cables (white and red) to the INPUT1 AUDIO
R and L jacks on the back of the TV and to lhe Audio Output Jacks on the VCR (sometimes
labeled OUT R L).
C. Connect the video cable (yellow) to the INPUT1 VIDEO iack on the back of the TV and to d_e
Vide() Output Jack on lhe VCR.
Connect
cable or antenna
to your VCR
Connect the coaxial cable from your cable outlet or antenna to the Input Jack on your VCR
(sometimes
labeled IN FROM ANTENNA or IN FROM ANT).
3.
Connect
the G-LINK
cable
to the TV
If you haven't
already
done
so, remove
the Demo
Pin from
the G-LINK jack. Then,
connect
fl_e
G-LINK
cable to the G-LINK iack on the TV. Next
step, place
one
of the wands
of the G-LINK
cable
to work
with your VCR (instructions
are on page
13).
Go to page
13
10
Chapter1
Advertisement
Table of Contents
