Table of Contents
Advertisement
Connections
S ' up
Step 3: Configuring
for a VCR
1.
If your "IV is connected
to a VCR, press OK (a screen appears
reminding
you to connect your G-LINK cable to your "IV and VCR).
If it is not, highlight No and press OK.
2.
Use llle up and down aITOWbuttons to highlight the brand of your VCR that
is connected
to the TV and press OK.
If your brand isn't listed, highlight Not Listed and press OK.
.
Tune
your VCR to channel
02.
Next, turn OFF your VCR. When
you
complete
these
steps,
press
OK to begin
testing.
Important Note: When code testing isin progress, don't touch your TV,VCR, or
any of the remote controJs for these products.
4.
Look at llle front of your VCR. If your VCR turned on automatically
and
changed
[o channel
09, the test was successtZfl. Highlight
Yes and
press OK.
If your VCR didn't change to channel 09, you can eilher choose No or Test
this code again.
If you think
your TV or remotes
might
have been
touched
during
the test,
tune your VCR to channel
02, turn off your VCR and highlight
Test this
code again.
If you don't
think
tlle test was
interrupted,
highlight
No. Tune
your VCR to
channel
02 and turn off your VCR. Press OK ([he GUIDE
Plus+ system
starts
testing
another
set of codes.)
Keep
following
the previous
insu'uctions
until the VCR finds
the
correct
code.
18
Chapter1
Advertisement
Table of Contents
