Table of Contents
Advertisement
Connections
Setup
Things to Consider Before You Connect
Protect
Against
Power Surges
•
Connect all components
before you plug any of their power cords into the wall outlet.
•
Turn off the TV and/or
component
before you connect
or disconnect
any cables.
•
Make sure all antennas
and cables
are properly
grounded.
Refer to the Important
Safety Instructions
on page
1.
Protect Components from Overheating
•
Don't block ventilation holes on any of the components. Arrange the components so that air can circulate
freely.
•
Don't stack components.
•
When you place components in a stand, make sure you allow adequate ventilation.
•
If you connect an audio receDer or amplifier, place it on the top shelf so the heated air from it won't flow
around other components.
Position Cables Properly to Avoid Audio Interference
•
Insert each cable firmly into the designated jack.
•
If you place components above the TV, route all cables down the side of the back of the TV instead of straight
down the middle of the TV.
•
lfyour antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin lead cables away
from audio]video cables.
Important
Stand
and Base Safety
Information
Choose the location
for your TV carefully.
Place the TV on a stand
or base that
is of adequate
size and strength
to
prevent
the TV from being
accidentally
tipped
over, pushed
off, or pulled
off. This could
cause personal
injury and[
or damage
the TV. Refer to the Important
Safety Instructions
on page
1.
Use Indirect Light
Don't place the TV where sunlight or room lighting will be directed toward the screen. Use soft or indirect lighting.
Cables Needed to Connect Components to Your TV
The pictures below show the cables needed for the connections represented in this book.
Audio/Video cables
Coaxial cable
S-Video cable
Component Video (yepbePr)
cables
4
Graphics
contained
within
this publication
are for representation
only.
Chapter
1
Advertisement
Table of Contents
