Table of Contents
Advertisement
Connections
S ' up
,
Highlight
the channel
to which
you have to rune your TV in order
to see
cable programming,
and press
OK (a screen
appeai=s
reminding
you to
connect
your G-LINK cable
to your "IV and cable
box).
Notes: Channel 03 isthe most common.
Choose Video1/AUX if your cable box is connected to your TV with audio/video
cables instead of a coaxial cable Go to page 7 for pictures of these cables.
4.
Highlight your brand of cable box, and press OK.
If your brand isn't listed, highlight Not Listed and press OK.
5,
Make
sure your cable
box is on.
Tune
the cable
box to channel
02 (use the remote
control
lhat came
with
your cable
box, or press
the channel
buttons
on the cable
box).
Press
OK (the GUIDE
Plus+
system
starts testing
codes).
Important
Note: When code testing is in progress, don't touch your TV, VCR, cable
box or any of the remote controls for these products.
,
Look at your cable box. If it is slill on and changed
to channel 09, the test
was successful.
Highlight
Yes, and press OK (STEP 3: Configuri*Tg fi)r a VCR
aOOea_).
If your cable box didn't change to channel 09 or turned itself off, you have
two choices: No and Test this code again.
Test this code again: If you think the TV, the cable box, or any of the
remote controls might have been touched
or bumped
during the test,
highlight
Test this code again and press OK (the GUIDE Plus+ system runs
the same set of codes).
No: If you don't think the test was interrupted,
highlight No and press OK
(GUIDE Plus+ system tests the next code).
Repeat the previous instructions
until the "IV finds the correct cable box
code. Follow the instructions
on the screen.
Note: If the TVcan't find your cablebox
code, a troubleshooting
checklistappears,
Carefully
review eachchecklistand follow the instructionson the screen
/7
Advertisement
Table of Contents
