Table of Contents
Advertisement
Coheir@!
np
To turn off all the RCA,
GE, and Proscan
components that are
connected to the T_,
press ON.OFF twice
within two seconds.
This feature
only works
with
most RCA, GE and
Proscan products,
PAUSE If you're operating
a VCR or DVD player wilh the remote control, press PAUSE when the
videotape
or disc is playing to pause playback.
PLAY If you're operating
a VCR or DVD playei; plays the video'tape or disc.
REC*VCR+
When llle GUIDE Plus+ program
guide is on the screen, press REC*VCR+ to program
your VCR to record a program. If lhe remote is in VCR mode, press REC*VCR+ to start recording.
REVERSE If you're operating
a VCR or DVD player wid_ dm remote control, press REVERSE to go
backwards
on a videotape
or disc.
SAT._LE
Puts the remote in SAT-CABLE mode.
If you set up tile Auto Tuning feature (Chapter
3), pressing the SKI'* CABLE button automatically
runes the "IV to the correct channel.
SKIP
If you press lllis button betbm you change lhe channel,
llle "IV waits 30 seconds
and
automatically
goes back to the original channel. Each time you press SKIp, you add 30 seconds
(i.e, if
you press SKIp two times before you change lhe channel,
llle "IV wails 60 seconds
and automatically
turns back to the original channel).
Press CLEAR to cancel skip timer.
SOUND
Displays lhe AUDIO PROCESSOR menu.
STOP If you're operating
a VCR or DVD playei, stops playing llle videotape
or disc.
TV Turns on the "IV and puts the remole in "IV mode. Also displays channel information.
VCli
Puts the remote in VCR mode. If you set up the Auto Tuning feature (Chapter 3), pressing the
VCR button automatically
tunes the "IV to the correct channel.
VPORT
Tunes _he "IV to _he VPORT input channel.
You can program
lhis button to control a cable
box, audio components,
a VCR, DVD or satellile receiver. When programmed,
changes the mode of
the remote when the button is pressed. To restore llle VPORT button to factory default mode
(unprogrammed),
press and hold VPORT, then press 1, 0, 0, and 0.
VOL (up and down)
buttons
Decrease
or increase llle "lV's volume.
WIIO*INPtrr
In "IV mode, press WHO-INPUT
to toggle lhrough the available Video Input channels
(FRNT, VID1/SVID1, VID2/CVID2, VPORT and the cmTent channel).
In SAT mode, press to select
available channel lists.
Using the WHO-INPUT
Button
Use the WHO*INPUT
butlon to toggle through the available input sources (PRNT, VID1/SVID1, VID2/
CV1D2, VPORT and lhe current channel)
and view the content from the component
you have
connected
to the TV.
1.
Press "IV to place the remote in "IV mode. Make sure that the content from the component
is
turned ON.
2.
Press WHO-INPUT
to tune to the available input source and view the component.
3.
Press WHO-INPUT
again to tune back to llle channel you were previously watching.
23
Advertisement
Table of Contents
