Storage Drives; Installation And Maintenance; Checking The Temperature Of An Nvme Drive - Supermicro SuperServer SYS-221GE-NR User Manual

3.6 Storage Drives

The system supports eight E1.S solid state drives (SSDs) that are 9.5mm or 15mm. Two M.2
SSDs are installed by the manufacturer.
Note: Enterprise-level storage modules are recommended for use in Supermicro servers. For
compatible storage drives, see the

Installation and Maintenance

Each E1.S SSD has two LED indicators.
To install or replace a drive, lift the latch on the front and pull. Carefully slide the new drive in.
Figure 3-5. Storage Drive Logical Drive Numbers

Checking the Temperature of an NVMe Drive

There are two ways to check using the BMC Dashboard.
Checking a Drive
•
BMC Dashboard > Server Health > NVMe SSD – Shows the temperatures of all NVMe
drives.
•
BMC Dashboard > Server Health > Sensor Reading > NVME_SSD – Shows the single
highest temperature among all the NVMe drives.
Chapter 3: Maintenance and Component Installation
SYS-221GE-NR product page.
34
0 1 2 3 4 5 6 7