Accessing The Programming Mode; Security Code - Viking K-1900-3 Technical Practice

P r o g r a m m
P r o g r a m m
A. Accessing the Programming Mode
1. Remote Programming
a. Connect the LINE IN port to a C.O. line or analog PABX/KSU station.
b. From a Touch Tone phone, call the line connected to the K-1900-3.
c. When the K-1900-3 answers, enter "," followed by the six digit security code, factory set to 845464 (see sec-
tion B on the following page). A double beep will indicate that programming has been entered.
d. Program as shown in sections B - G.
e. To exit programming, enter "##7" or do NOT enter any Touch Tones for approximately 20 seconds. Three
beeps will be heard, followed by an automatic disconnect.
2. Local Programming Using the Security Code (from entry phone)
a. Take the phone connected to the PHONE port off-hook.
b. Enter a "," followed by the six digit security code (see section B). A double beep will indicate that program-
ming has been entered.
c. Program as shown in section B - G.
d. To exit programming, simply hang up the entry phone (push the "Call" button on the K-1700-3).
3. Local Programming Without the Security Code (from entry phone)
a. Move the PROGRAMMING switch to the ON position.
b. Take the phone connected to the PHONE port off-hook. A double beep will indicate that programming has
been entered.
c. Program as shown in section B - G.
d. When finished, the programming switch must be placed back in the OFF position for normal operation.
e. To exit programming, simply hang up the entry phone (push the "Call" button on the K-1700-3).
B. Security Code
A six digit number may be used to access the programming mode. The security code has been factory set to 845464
(V-I-K-I-N-G). It is recommended that you change the security code to a personal 6 digit number as follows:
1. Access programming as shown in section A.
2. Enter your new security code followed by ##5.
3. To exit remote programming, do NOT enter any Touch Tones for at least 20 seconds. To exit local programming
simply hang up the entry phone.
Note: The security code must be six digits in length and MUST NOT contain a , or #. If you have forgotten your secu-
rity code, see section "A. Local Programming Without the Security Code."
C. Tenant's Phone Numbers and Keyless Entry Codes
The K-1900-3 can be programmed with up to 150 tenant phone numbers and up to 150 keyless entry codes and 1
master keyless entry code. A tenant may activate the door strike from the entry phone by dialing a "#" followed by their
keyless entry code. When a given tenant moves out of the complex, the phone number and keyless entry code for
that tenant may be cleared without affecting any other tenant's phone numbers or their keyless entry codes.
Note: The keyless entry codes should all be the same number of digits, either 4, 5 or 6. A keyless entry code may
be programmed without a phone number.
1. Programming a Phone Number Only
While in programming, enter the tenant's phone number + "#" + memory location number (000 - 149).
Example: 5551212 # 001
2. Programming a Phone Number and Keyless Entry Code
Note: Keyless entry codes MUST be programmed while programming the phone numbers into the memory loca-
tions (000 - 149).
While in programming, enter the tenant's phone number + "#," + the keyless entry code for the tenant (4-6 digits)
+ "#" + memory location number (000 - 149). Example: 5551212 #, 123456 # 001
i n g
i n g