Star SP742 Series Hardware Manual page 18

3-8-4. Setting up Auto Connection
Setting up from the Main Unit for the SP742
◆
Note: The following procedure explains how to change the Auto Connection function setting from ON to OFF.
If you want to change it from OFF to ON, please follow the same procedure.
(1) When paper is loaded in the printer and it is turned on, the [POWER] LED(green) on the front of the
printer turns on.
(2) If you hold down the [RST] button on the back of the printer for at more than five seconds, initial operations are
performed in the same way as when the power is turned on, and the LEDs on the front of the printer flash. If you
press the [RST] button when the printer is placed upright, place it horizontally again while the LED is flashing.
(3) The following information is printed. After that, turn the printer off and then back on again to set "Auto
Connection" to OFF.
< Current Setting >
Auto Connection : OFF
To enable this setting, turn
Printer Power OFF and turn ON.
(4) To make sure "Auto Connection" is set to OFF correctly, perform self-printing as described in "5-4-1. Self
Printing Mode"
Setting from the Software
u
After pairing your device and the SP700, change "Auto Connection" in the following application provided by our
company.
l iOS: Download "Star Setting Utility" from the following Web site.
http://www.star-m.jp/prjump/000003.html
l Android: Download "Star Setting Utility" from the following Web site.
http://www.star-m.jp/prjump/000004.html
l Windows: Download "Star Bluetooth Utility" from the following Web site.
http://www.star-m.jp/prjump/000006.html
RST button
– 14 –