Star SP742 Series Hardware Manual page 10

3-2-2. RS-232 Interface Cable
(1) Make sure the printer is turn off.
CAUTION
Before connecting/disconnecting the interface cable, make sure that power to the printer and all the devices
connected to the printer is turned off. Also make sure the power cable plug is disconnected from the AC outlet.
(2) Connect the interface cable to the connector on the rear panel of the printer.
(3) Tighten the connector screws.
3-2-3. USB Interface Cable
Affix the ferrite core onto the USB cable as shown in the illustration below and make sure to pass the cable through the
cable support as shown in the illustration.
– 6 –