CYCLE PARTS
7.10.5.
CHECKING THE COMPONENTS
Tube
•
Check the sliding surface, that must be neither lined,
nor scratched. Slight lines can be eliminated by sand-
ing the surface with wet sandpaper (grain 1). If the
lines are deep, change the tube.
•
By means of a comparator, make sure that any curving
of the tube be lower than the limit value. If it exceeds
the limit value, change the tube.
Curving limit: 0.2 mm.
CAUTION
NEVER straighten a curved tube, since its
structure would be weakened, thus making the
use of the vehicle quite dangerous.
Slider
•
Make sure that there are neither damages, nor cracks.
Otherwise, change it.
Spring
•
Check the integrity of the spring.
Pumping element
•
Check the integrity of the pumping element. If you ob-
serve any damage, change it.
7 - 70
WWW.PlanDeGraissage.ORG
LEONARDO 250 - 300